Drill Square MEDIUM (Drill Guide 90 Degrees)

Special Air Services-Canada Inc. Drill Square MEDIUM (Drill Guide 90 Degrees) Drill Square - Drilling Aid
$49.50

Drill Square MEDIUM (Drill Guide 90 Degrees)

0 Reviews
CAD $49.50
Drill Square MEDIUM (Drill Guide 90 Degrees)
Drill Square MEDIUM (Drill Guide 90 Degrees)
Drill Square MEDIUM (Drill Guide 90 Degrees)
Drill Square MEDIUM (Drill Guide 90 Degrees)
Drill Square MEDIUM (Drill Guide 90 Degrees)
Drill Square MEDIUM (Drill Guide 90 Degrees)
Drill Square MEDIUM (Drill Guide 90 Degrees)
Drill Square MEDIUM (Drill Guide 90 Degrees)
Drill Square MEDIUM (Drill Guide 90 Degrees)
Drill Square MEDIUM (Drill Guide 90 Degrees)
Drill Square MEDIUM (Drill Guide 90 Degrees)
Drill Square MEDIUM (Drill Guide 90 Degrees)

Drill Square MEDIUM (Drill Guide 90 Degrees)

CAD $49.50
Model Number: 9536814-301
Drill Square - Drilling Aid
Maximum quantity exceeded
Minimum purchase amount of 0 is required
Maximum purchase amount of 0 is allowed
49.500
12 Left in Stock
Facebook
Twitter
Email
  • Description
  • Customer Reviews (0)

This Listing is for ONE ONLY 9536814-301 MEDIUM DRILL SQUARE. 

Each Drill Square is machined from O-1 "Pennsylvania USA" tool steel, heat treated and then tempered to Rockwell RHC 60+.  As you can see in the images there is a 90 degree “V” groove machined on the outside edge of each leg of the Drill Square. 

Sometime due to cramped quarters, awkward body positions or just plain hard to reach situation it is very difficult to always drill a hole at 90 degrees to the surface of the part or component.  Used correctly this Drill Square can virtually eliminate angular errors.

To use this drilling aid, place one leg of the Drill Square against the surface to be drilled.  Then place the point of the drill at the intended location for the fastener hole.  Rotate  the drill motor/drill to contact  the center of the "V" groove which is perpendicular to the surface to be drilled.  The drill is pressed against the "V" groove over the entire 1.5" length.  This ensures the drilling axis is at 90 degrees to the surface.  Used correctly, the resulting fastener hole will be at 90 degrees to the work surface.

The legs of this Drill Square are equal and measure 1.5" in length. 

Check out other Sizes of Drill Squares shown in one of the photos.

 

There are no reviews yet, submit yours in the box provided.
Submitting Your Review, Please Wait
Your Review Has Been Submitted Successfully

Add a review for Drill Square MEDIUM (Drill Guide 90 Degrees)

You must include a title, rating, and message in your review.
Your Review Title
Your Rating
Your Review